No description
Find a file
2026-11-08 09:50:39 +01:00
printer.cfg Hogere Z acceleratie en max speed, om blob bij laagwisseling bij printen op 200% te verminderen 2026-08-17 09:22:58 +02:00
PrusaSlicer_config_bundle_Klipper_ultimaker.ini filament on Ultimaker is 2.85 or 3 mm, not 1.75... 2026-11-08 09:50:39 +01:00
README.md add readme.md zodat wikipage weg kan 2026-10-05 15:27:19 +02:00

Config klipper UM2+extended

Configuration for Klipper for the Ultimaker 2+ extended in the MakerSpace

Both the printer.cfg for klipper and the config bundle .ini for PrusaSlicer can be found in this git repository

Note: If you are using these for another printer, parameters such as input shaper, acceleration, pressure advance, and PID might be different. Even on another UM2+. So only use this as a starting point and retune these for your individual printer!

be careful - your Z-axis length might differ - do not ram the nozzle trough the glass bed or turn it into an engraver, carefully lower Z and change the setting of max_length for your printer!